FAQ |
Calendar |
SEARCH |
Today's Posts |
|
Mobil & Motor Diskusi antar pemilik mobil dan motor. Sharing tips dari mulai spareparts,kerusakan, hingga bengkel terbaik bisa didapat disini |
|
Thread Tools |
#1
|
|||
|
|||
Z axis won’t move on Geeetech Prusa I3 X
Hi,
When using Repetier-host to move the Z axis, I only get a noise but not any movement on the Z axis. The noise is like the motor is trying to turn but are not strong enough. (X and Y axis works fine) When I try to turn the threading rods with my hand they are quite hard to turn. I don't know if the rods are bent, the linear bearings are bad or if I have done something wrong. What I have tried to fix this: I have eyeballed all the roods, and they look pretty straigh. I have lubricated the rods with oil. I have check that the threading rods are not stuck in the holes at the top. I don't know what more I can do. Can you help me to figure out what is wrong? Any help will be apprecited. I didn't find the right solution from the Internet. References: https://www.geeetech.com/forum/viewtopic.php?t=16917 Infographic animation company Thank you. Terkait:
|
|
|