RocketCable
12th December 2013, 08:39 AM
<div id="post_message_6149985">
misi boz2 gw mo jual power performa ZP-3500..
neh power 2 ch..
udah pernah d servis..
neh speknya:
* Ultra stable pwm (pulse width modulated) mosfet power supply
* 2 ohm stable operation with output power increase
* built-in crossover top control
ch �: variable hi-pass filter (40hz-1khz)
variable low-pass filter (40hz-250hz)
* tri-mode cap ability for simultaneous hook-up of two stereo channels and subwoofer
* super bass control : 0-12db
* soft-start delay turn-on circuit
* automatic remote on/off switching
* power on and protect led indicators
* bult-in overload protection circuit
* bult-in over current protection circuit
* bult-in overheat protection circuit
* gold plated rca input and transparent terminals
* line out rca jack
Technical Specification :
4 ohms maximum output @0.03% 700Watts
4ohms bridget mono output @0.02% THD 1 x 700W
2 ohms WRMS output @0.1 THD 2 x 350W
Low pass filter 40Hz - 250Hz
High pass filter 40Hz - 1KHz
Frequency response 10 - 40000Hz
Signal to noise ratio 100dB
Stereo separation >55dB
Input sensitivity 145mV-2.4V
Input impedance 10 Kohms
Operation voltage DC 12V
Speaker impedance @ stereo driven 4 Ohms
Fuse rating 25Ax1
Dimension (WHD) mm 280x50x244
misi boz2 gw mo jual power performa ZP-3500..
neh power 2 ch..
udah pernah d servis..
neh speknya:
* Ultra stable pwm (pulse width modulated) mosfet power supply
* 2 ohm stable operation with output power increase
* built-in crossover top control
ch �: variable hi-pass filter (40hz-1khz)
variable low-pass filter (40hz-250hz)
* tri-mode cap ability for simultaneous hook-up of two stereo channels and subwoofer
* super bass control : 0-12db
* soft-start delay turn-on circuit
* automatic remote on/off switching
* power on and protect led indicators
* bult-in overload protection circuit
* bult-in over current protection circuit
* bult-in overheat protection circuit
* gold plated rca input and transparent terminals
* line out rca jack
Technical Specification :
4 ohms maximum output @0.03% 700Watts
4ohms bridget mono output @0.02% THD 1 x 700W
2 ohms WRMS output @0.1 THD 2 x 350W
Low pass filter 40Hz - 250Hz
High pass filter 40Hz - 1KHz
Frequency response 10 - 40000Hz
Signal to noise ratio 100dB
Stereo separation >55dB
Input sensitivity 145mV-2.4V
Input impedance 10 Kohms
Operation voltage DC 12V
Speaker impedance @ stereo driven 4 Ohms
Fuse rating 25Ax1
Dimension (WHD) mm 280x50x244